Sunglaze Side Cover 6.0m

The Sunglaze Side Cover 6.0m is the inner finishing profile of the Sunglaze side joiner. It completes the side joiner assembly after the base and cap are in place, giving the underside of the trimmed sheet edge a clean, finished face. It is the piece that makes a cut sheet edge look deliberate from inside the room rather than simply trimmed off.

The profile is supplied in a 6.0m length and clips into the side joiner assembly along the perimeter of the roof. It is aluminium, so it matches the rest of the Sunglaze range, resists corrosion, and needs no painting or ongoing maintenance.

When you cut a Sunglaze sheet down in width to suit your roof, the cut edge needs the full side joiner set: the base anchors it, the cap seals and finishes the outer face, and the cover completes the inner face. Ordering the cover at the same time keeps the whole edge assembly in one profile and one delivery.

Key Features

• Aluminium profile, the inner finishing piece of the side joiner
• Completes the side joiner assembly on a trimmed sheet edge
• 6.0m length for a long clean run
• Gives the underside of the edge a clean finished face
• Corrosion resistant and maintenance free

Specifications

Applications

• Finishing the inner face of a trimmed sheet edge
• Completing the Sunglaze side joiner assembly
• Full system builds on verandas, pergolas and carports

What You Need To Complete The Job

The side cover is the third piece of the side joiner set. It works with the Sunglaze Side Base and the Sunglaze Side Cap, with the Sunglaze Side End Caps closing the ends. All the parts are in the Sunglaze category.

Frequently Asked Questions

What does the side cover do?

The side cover finishes the inner face of the side joiner assembly. After the base and cap are in place on a trimmed sheet edge, the cover clips in to give the underside a clean, complete profile.

Is the side cover needed if the edge is not visible?

Even a hidden edge benefits from the cover because it completes the assembly and stops debris sitting in the open profile. For a visible underside, such as a pergola ceiling, it is essential for a finished look.

What length is supplied?

The side cover is supplied as a 6.0m length. Trim it to fit a shorter edge run, or join sections for a longer perimeter.

Does the side cover match the other Sunglaze profiles?

Yes. It is part of the same aluminium range as the base, cap, rafter and joiner profiles, so it carries the same finish and reads as one continuous system.

Do I need the cover for a full-width sheet?

No. The side joiner set, including the cover, is only needed where a sheet has been cut down in width. A full-width sheet uses its manufactured edge and does not need the side assembly.