Supabit Phillips PH2 Screwdriver Bit 150mm 5 Pack

The Sutton Tools Supabit S151 is a 5 pack of Phillips PH2 screwdriver bits at 150mm long, with a torsion neck design specifically suited to high torque applications. The extra length reaches screws that sit deep in a housing or behind an edge, and the Phillips design absorbs torque peaks to reduce slippage and breakage. Supabit Extreme Impact bits are developed for the high torque output of an impact driver.

Key Features

• 5 pack of Phillips PH2 screwdriver bits
• 150mm length for reaching recessed and deep set screws
• Phillips design absorbs torque peaks, reducing slippage and breakage
• Torsion neck design specifically suited to high torque applications
• 1/4 inch hex shank fits impact drivers and quick change adapters

Specifications

• Drive: Phillips PH2
• Length: 150mm
• Pack: 5 pieces
• Series: Supabit Extreme Impact
• Shank: 1/4 inch hex

Applications

• Driving PH2 screws in recessed frames, housings and panels
• Impact driving in framing and assembly work
• Reaching screws a short bit cannot get a straight drive on
• General Phillips screw driving with an impact driver

What You Need To Complete The Job

Keep the hex H5 bits and Robertson R2 bits for the other common drives, and add a magnetic nutsetter set for hex head screws. See the General Hand Tools range for more driving accessories.

Frequently Asked Questions

Why choose a 150mm Phillips bit?

The 150mm length lets you drive screws that sit deep in a housing, behind a frame or in a recessed profile, where a short bit cannot get a straight drive. It also keeps your hands clear of the work. For general driving where reach is not an issue, a 50mm or 100mm bit is easier to control.

What is a torsion neck bit?

A torsion neck is a machined section of the bit that flexes slightly under load, which absorbs the torque peak when the screw seats and stops the bit snapping. It is a feature of the Supabit range built for impact drivers. The result is a longer lasting bit on high torque work.

Can I use these in an impact driver?

Yes. The 1/4 inch hex shank fits impact drivers and quick change adapters, and the Supabit Extreme Impact range is developed for the high torque output of an impact driver. The torsion neck is specifically designed for the stresses of impact driving.

How do I know when to replace a bit?

Replace the bit when the tip starts slipping out of the screw head or when the cross point looks worn. A worn Phillips tip will round off screw heads and slow the job down. With a 5 pack you always have a spare ready, which keeps the work moving.