Double Ended Panel Drill 10 Pack

This 10 piece set of double ended panel drill bits is engineered for precision drilling in sheet metal and panel work. Each bit has two cutting ends, so when one end dulls you flip it around and keep working, which effectively doubles the life of the set. The compact panel profile and 135 degree split point make clean, accurate holes in thin gauge metals and aluminium.

Key Features

• Double ended design: two cutting ends per bit, doubles lifespan and reduces downtime
• Compact panel profile about 51-55mm long with a 12-18mm flute for tight spaces
• M2 high speed steel with a bright finish for hardness and wear resistance
• 135 degree split point for self centring starts and clean holes with minimal burr
• 10 piece set for dependable backup on the job

Specifications

• Material: M2 high speed steel, bright finish
• Tip: 135 degree split point
• Length: approximately 51-55mm (description-sourced)
• Flute: 12-18mm (description-sourced)
• Sizes: 3.0-3.2mm for rivets up to 3mm (1/8 inch), 4.0-4.5mm for rivets up to 5mm (3/16 inch)

Applications

• Drilling rivet holes in roofing panels and cladding
• Sheet metal fabrication, guttering and HVAC ducts
• Drilling thin steel and aluminium in panels and bodywork
• General panel work where a clean, burr free hole matters

What You Need To Complete The Job

Drill the holes with these bits, then set the rivets with a hand riveter and the correct pop rivets. For a No.30 single size set, the double ended panel drill 10 piece is an option. See the General Hand Tools range for more drilling and fastening tools.

Frequently Asked Questions

What makes a panel drill different?

A panel drill is a compact bit built for drilling thin sheet metal and panels, where a standard twist drill can wander or tear the material. The short length and the split point give a clean start, and the double ended design means you get two cutting ends from each bit.

What sizes are in this set?

The listing gives sizes around 3.0-3.2mm for rivets up to 3mm (1/8 inch) and 4.0-4.5mm for rivets up to 5mm (3/16 inch). The set is a 10 pack. Match the drill to the rivet so the rivet sits snug in the hole, and check the listing for the exact diameter spread.

Can I use these on aluminium?

Yes. The compact size and split point make them a good fit for thin aluminium, steel and other sheet metals. Use low speed and moderate pressure, and support the material so it does not flex while you drill. A cutting fluid helps keep the hole clean on thicker or coated metal.

How do I flip the bit?

When the end in use dulls, loosen the chuck, pull the bit out, flip it end for end and tighten again. The second cutting end is ready to go, which keeps the job moving without stopping to sharpen or replace bits. It is the simplest way to get double the working life from a panel drill.